ObjectiveTo explore the parameter selection of different sample size estimation methods and the differences in estimation results in single-group target value clinical trials with rate as the outcome evaluation index. MethodsWe conducted a literature review to assess the method of target value selection for single-group target value clinical trials. Then, different values of target value (P0), clinical expected value (P1), and class II error level (β) were set through numerical simulation. Sample size results estimated using different sample size estimation methods were obtained using PASS software. The coefficient of variation, range/mean, analysis of variance and other methods were used to compare the differences between different methods. ResultsAnalysis of the data simulation results showed: when the expected value P1 was fixed, the sample size first decreased rapidly and then decreased slowly along with the increase or decrease of the targeted value P0 on both sides of the sample size limit value. When the difference between P0 and P1 was within 0.15, the ratio before and after correction could be controlled within 0.9. When the difference between P0 and P1 was more than 0.6, the ratio before and after correction approached 0.5. When P0+P1≈1, the ratio of different standard error choices (Sp0 or Sp1) to the estimated sample size was close to 1. When 0.65<P0+P1<1.35, the ratio of different standard error choices (Sp0 or Sp1) to the estimated sample size was about 3:1. When the confidence was 0.8, P0 and P1 were between 0.25 and 0.75 and between 0.20 and 0.80, respectively. We found little difference among the sample sizes estimated using these five methods (CV<0.10, range/mean<0.2). ConclusionThere are some differences among different sample size estimation methods, however, when P0 and P1 values are around 0.5, the differences between different methods are small, suggesting that appropriate methods should be selected for sample size estimation.