ObjectiveTo evaluate the stability of the fixation technique for the crossed rods consisting of occipital plate and C2 bilateral lamina screws by biomechanical test.MethodsSix fresh cervical specimens were harvested and established an atlantoaxial instability model. The models were fixed with parallel rods and crossed rods after occipital plate and C2 bilateral laminae screws were implanted. The specimens were tested in the following sequence: atlantoaxial instability model (unstable model group), under parallel rods fixation (parallel fixation group), and under crossed rods fixation (cross fixation group). The range of motion (ROM) of the C0-2 segments were measured in flexion-extension, left/right lateral bending, and left/right axial rotation. After the test, X-ray film was taken to observe the internal fixator position.ResultsThe biomechanical test results showed that the ROMs in flexion-extension, left/right lateral bending, and left/right axial rotation were significantly lower in the cross fixation group and the parallel fixation group than in the unstable model group (P<0.05). There was no significant difference between the cross fixation group and the parallel fixation group in flexion-extension and left/right lateral bending (P>0.05). In the left/right axial rotation, the ROMs of the cross fixation group were significantly lower than those of the parallel fixation group (P<0.05). After the test, the X-ray film showed the good internal fixator position.ConclusionThe axial rotational stability of occipitocervical fusion can be further improved by crossed rods fixation when the occipital plate and C2 bilateral lamina screws are used.