Foam stability affects the efficacy and incidence of side effects of foam sclerotherapy. Exploring the relationship between foam pressure difference and foam stability can provide ideas and basis for obtaining more stable foam. In the experiment, sodium cod liver oleate foam was selected, and poloxamer 188 (concentration of 0%, 4%, 8%, 12%) was added to realize the change of foam pressure. By using the self-written program to process the foam pictures, the foam pressure difference and the relationship between the foam stability indicators (water separation rate curve, half-life) and the foam pressure difference were obtained. The results showed that at first the foam pressure increased with the increase of the concentration, and then it decreased with the increase of the concentration and reached a peak at the concentration of 4%. The foam pressure difference decreases continuously with the increase of decay time. When the additive concentration is low, the foam average pressure difference increases. And if the additive concentration is too high, the foam average pressure difference decreases. The smaller the foam pressure difference is, the better the foam stability is. This paper lays a foundation for the research on the stability of foam hardener.
Three dimensional (3D) printing is considered as an advanced manufacturing technology because of its additive nature. Electron beam melting (EBM) is a widely used 3D printing processes for the manufacturing of metal components. However, the products printed via this process generally contain micro porosities which affect mechanical properties, especially the fatigue property. In this paper, two types of EBM printed samples of the Ti-6Al-4V alloy, one with a round cross section and the other with a triangle cross section, were employed to investigate the existence of porosities using computed tomography (CT). Statistical analyses were conducted on the number, volume, shape, and distribution of pores. The results show that small pores (less than 0.000 2 mm3) account for 80% of all pores in each type of samples. Additionally, to some extent, the shape of sample has influence on the number of micro porosities in EBM made Ti-6Al-4V. The sphericity of the pores is relatively low and is inversely proportional to pore volume. It is found that re-melting on the free surface effectively reduce pore density near the surface. This study may help produce a medical implant with better fatigue resistance.